DIRT_NASTYY_ Posted July 16, 2018 Share Posted July 16, 2018 Hi everyone, New to this forum but stoked to get working on my new project! I just picked up a 92 Comanche, I was going to rebuild my old Cherokee but couldn't pass up the deal I found on this MJ! It's bone stock, LWB, 2WD. I am going to use the parts off my Cherokee to convert it over to 4WD. I know I have to get the rear drive shaft shortened when I convert it, but it's going to be a month or two before I can swap in the transmission and transfer case. I'm wondering if I can can add 4" of lift and run the stock rear drive shaft for the time being, couldn't find anything about this. Link to comment Share on other sites More sharing options...
Pete M Posted July 16, 2018 Share Posted July 16, 2018 the stock MJ driveshaft will work fine for a 4" lift on a 2wd Link to comment Share on other sites More sharing options...
DIRT_NASTYY_ Posted July 16, 2018 Author Share Posted July 16, 2018 2 hours ago, Pete M said: the stock MJ driveshaft will work fine for a 4" lift on a 2wd Awesome, at least I can get out in the desert sooner than later! Link to comment Share on other sites More sharing options...
HOrnbrod Posted July 16, 2018 Share Posted July 16, 2018 2 hours ago, Pete M said: the stock MJ driveshaft will work fine for a 4" lift on a 2wd Agree, especially on a LWB. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now