Mattman6 Posted March 20, 2017 Share Posted March 20, 2017 Well I decided to start tearing into the interior to get my floor owns squared away. I attempted to take my passenger lower seat belt off to remove the interior trim pieces. Well the rust was so bad, that the entire attachment came out. Has anyone dealt with this before? Would love some ideas and possibly some pics if there are any out there. Link to comment Share on other sites More sharing options...
1989 comanche mj Posted March 20, 2017 Share Posted March 20, 2017 I cut a section from a donor cherokee that had the seatbelt nut attached and welded it over where the original should be. But that bolt may back out if you heat it till it glows. Link to comment Share on other sites More sharing options...
Mattman6 Posted March 20, 2017 Author Share Posted March 20, 2017 I cut a section from a donor cherokee that had the seatbelt nut attached and welded it over where the original should be. But that bolt may back out if you heat it till it glows. Great idea! I was thinking about welding a seat belt nut to the 2x6 piece of metal in the pic. The 2x6 is my rocker and seems to me like a good place to attach the seat belt too. Link to comment Share on other sites More sharing options...
Big Dan Posted September 27, 2017 Share Posted September 27, 2017 Is the above what you ended up doing? Link to comment Share on other sites More sharing options...
Mattman6 Posted November 23, 2017 Author Share Posted November 23, 2017 On 9/26/2017 at 9:31 PM, Big Dan said: Is the above what you ended up doing? No I just ended up drilling a hole in the metal and putting a nut on the other side. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now