gregz0r Posted October 13, 2014 Posted October 13, 2014 Converting my 2wd SWB to 4wd and in need of a rear axle. Located in Southern Cali and am willing to pick up if not too far away. Thanks
AeroNautical Posted October 13, 2014 Posted October 13, 2014 Driveshaft, or axle? Title and post say two different things, haha. If you do need the driveshaft, you can have your 2wd shaft cut down. Easier than trying to find a 4wd MJ driveshaft. If it is the axle your looking for, what kind? Dana 35, Chrysler 8.25, Dana 44?
shelbyluvv Posted October 13, 2014 Posted October 13, 2014 Engine and transmission matter as well if you are looking for a driveshaft.
gregz0r Posted October 14, 2014 Author Posted October 14, 2014 Sorry I must have been half asleep while typing. I am in need of the driveshaft not the axle. It is going into my 4.0 Renix with AX-15 and NP231.
AeroNautical Posted October 14, 2014 Posted October 14, 2014 Sorry I must have been half asleep while typing. I am in need of the driveshaft not the axle. It is going into my 4.0 Renix with AX-15 and NP231. What rear axle do you have? Any lift? Let us know this and we can get you an exact measurement for the driveline shop. I got mine cut, new u joints installed (I supplied) and balanced/cleaned and painted for $60, with a higher spline yoke installed as well. Very reasonable.
gregz0r Posted October 20, 2014 Author Posted October 20, 2014 I have a Dana 44 rear axle with about 5" of lift
Recommended Posts