reubj Posted February 24, 2014 Share Posted February 24, 2014 Yesterday I was running some new wiring for guage illumination. As I was check things I noticed the radio was no longer coming on. I pulled it and found that the constant 12V (pink wire) is now only .22V (yes, point 22 volts; probably back-feed?). I can't think of anything I did that might cause this except rustling some of the harness around. Any thoughts? Thanks. Link to comment Share on other sites More sharing options...
JeepcoMJ Posted February 24, 2014 Share Posted February 24, 2014 Manual trans? Assuming you have a leaking master cylinder, and that is why you were replacing the ip wire, u probably have the same issue now with that. Link to comment Share on other sites More sharing options...
HOrnbrod Posted February 24, 2014 Share Posted February 24, 2014 Check the radio chassis ground wire. Probably pulled off........ Link to comment Share on other sites More sharing options...
reubj Posted February 24, 2014 Author Share Posted February 24, 2014 No leaky master cylinder. Previous owner added SunPro gauges and did not bother with the illumination. I noticed there is nothing in the 30A CB slot in the fuse block. I would assume that would be where the 12V constant originates from. I guess there never has been. Where else could the pink wire be getting its power? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now