peugeot trans mount conversion question

[Mongo]

I need a new mount after 250k miles. Has anyone modified an ax15 mount (way cheaper) to work? or is there an aftermarket one that is cost less than any I have found on the internet.

[Geonovast]

Sounds like more than enough reason to track down an AX-15. :clapping:

[HellBent]

i recall running across something online about someone who did that. it was along the lines of making an "adapter plate" to make the ba-10 attach to the ax-15 mount. it didn't look terribly involved-IF you have the fab ability, materials, and time. i'll see if i can find that page again...

[BORDENCOMANCHE]

Scrap piece of metal, a 5/8 drill bit and a welder. Tada!, weld the scrap piece of metal onto the mount, drill holes in the plate, done.

[Mongo]

I will get a transmission as soon as this one completely dies, but don't want to hasten the death because of a worn out rubber mount. Still working on other issues that are higher priority, like hanging the rust free door that I just purchased as well as installation of some remanned fuel injectors. I could not find a thread on our website to a conversion, and the XJ site will not allow you to search unless you open your wallet a little.