JeepFanatik

You might have already answered this. What paint are you using on the chassis? Steel-it black???

Could anyone with OEM injectors tell me a part number or the best place to get some O-Rings? I just recently completed upgrading to the H.O. Exhast Manifold and upon putting my fuel rail back together i have a massive leak from all injectors. Noticed the o-rings are flattened out so pretty sure i just need replacements.

Ended up ordering a felpro from Summit Racing and it fit. Glad i'm not the only one to experience that.

Has anyone ran into an issue with either Renix or H.O. header where the donut gasket to the downpipe doesn't fit? This ebay header i picked up the donut looks like it is the exact same size as the pipe it needs to slide on.

Anyone know if the Standard Motor Products KS99 is compatible with renix? This is what i'm getting when looking for a new knock sensor for my 88 4.0. Looks totally different than the OEM unit but still appears to have the same connector. Any help appreciated.........hoping to order one today.

Thank you sir!! I assume the plug for the renix intake.....that is the part number written below it? And i assume per the writeup i use a renix gasket? I do like the idea of replacing the exhaust manifold and intermediate pipe with HO variants to get rid of the EGR bung. I was already wanting to replace the intermediate pipe.

Anyone know what i can use as a plug on the intake and exhaust manifolds to remove the EGR tube between them? This is the last bit i need to take care of for EGR delete. Thanks everyone!

So how does one remove the lenses off of a set of MJ taillights? I guess it has glue that you could pop them in an oven for a few minutes to then pry apart?

I had found this link from another post a while back. I just ordered a pair. Seems they are in stock if anyone else needs some. https://infparts.com/product/on-off-map-light/

New to me Kenwood head unit. Also i used some flat ABS to fill the holes in the dash bezel so i can eventually add some extra gauges and switches. Still need to get this piece painted but i'm close.

Started working on deleting the load sending valve in the rear since it was not working and leaking to begin with. I'll eventually go with a different proportion valve up front.

This was right after i pulled the interior to check the floors. We got some repair to do here.

Picked up a bench seat recently. Need to get it to my friend who runs his own upholstery shop and get it recovered. She's in pretty good shape otherwise.

Replaced the rear brakes and e-brake cables. I have the front e-brake cable as well but that won't get installed until after i complete rust repair on the floors.

Couple more pics of the engine bay as it sits today.