Jump to content

jeepman 87

Members
  • Posts

    136
  • Joined

  • Last visited

Everything posted by jeepman 87

  1. Are the metric ton coil springs bigger than normal 4x4 coil springs
  2. Where can I get manual window regulators to fit my 99 doors? Will I have to go to dealer?
  3. Only have wires inside doors no harness after door and I think switch is bad on pass side
  4. Can I use my 89 window regulator ( manual ) inside my 99 doors that are power ( I hate them won't work )
  5. Got 99 fenders doors and nose all bolted on and working, now to get doors wired
  6. My fog light switch is on the left next to my cargo light switch, don't know what the switch next to power trans switch is
  7. So some are pre wired for power windows, and if so what models if not all. I'm only asking because I have the week off and decided to change nose, fenders, and doors. ( my mj is a 89 eliminator fully loaded). Also what is the switch next to power trans button, I can hear something clicking under hood every time I hit switch
  8. Has there ever been an mj that had power windows (factory) or ones that have been pre wired? :dunno:
  9. jeepman 87

    4x4 swap

    Got everything but front axle ( which I will be getting from jy ) to change my 2wd 89 eliminator to it's true meaning 4x4, also have 99 nose fenders and doors to be swapped ( all my 4x4 parts came from my 87 long bed with danna 44 but sucky vacuum front axle ) So I'm almost ready to get started :banana:
  10. I have a 87 long bed 4x4 and I need to know if I can swap leaf springs and axle onto my 89 short bed eliminator two wheel drive
  11. Pennzoil all the way
  12. Sounds good but where you from and what's shipping
  13. Like to find a short bed roll bar near Indiana
  14. What size is the nut at the end of the front axle shaft ( so I can change hub assembly )
  15. Can I put a 97+ windshield seal on a 89 mj
  16. How hard is it to change to a 97+ cooling system
  17. Will my 01 xj seats bolt to my 89 mj brackets
  18. jeepman 87

    Drive shaft

    Looking for a 4-wheel drive short bed drive shaft
  19. Cool thanks alot I would also like to ask is there a panel on the floor that bolts out and the 4-wheel drive lever bolts in
  20. On a 2-wheel drive console can you cut out enough to put in the four wheel drive lever and stil put in the surrounding ring that has the 4-hi and 4-low markings
  21. Just like to know where to mount 97 or newer strikers on door jam to get close fit :dunno:
  22. jeepman 87

    Brackets

    Like to find some bucket brackets for my 87 but not to much :peek:
  23. My wife came home today from work and asked me if I wanted to get some parts for my truck ( I almost fell over ) so we went to napa and got prices for a major rebuild kit for motor valve job and get block ready so after I get floor boards in motor done I can start on body work and finally get her on the road
  24. Just like to know where I can get or order new floor boards or floor pans :huh???:
  25. I guess I'll try this again since one guy said he would send one then never heard from again but I would like to find a complete cluster with tach,oil,amps,and fuel for my 87 manche with the 4.0
×
×
  • Create New...