ghetdjc320 Posted December 30, 2021 Share Posted December 30, 2021 If anyone has been following my efi project they may recall I made this adapter so I could plug in an aftermarket ecu to the factory obd1 connector. I built this by desoldering the 60 pin female connector from a spare ecu then soldering on a full set of pigtails onto each pin. Once that was done I potted all the unit. Once cured, each wire was tested for continuity to the pin. This unit works nice and can prevén having to make a custom harness for your engine using an aftermarket ecu. There is one similar product on the market and it’s about $350. I’ll sell this one for $75 plus shipping if anyone wants it. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.