Anyone make good replacement rockers?

[1989 comanche mj]

One side of my Comanche has a rocker repair, basically bent sheet metal bondoed on the rocker and welded underneath.  Its horrible.   I have to replace the rocker, can't patch over it like a rusted factory rocker.  Are there any usable ones out there now?

[krustyballer16]

Negative. You'll have to make your own like I did out of ones out there. Gotta cut em apart and weld em back together

I'm gonna try to see if I can have them reproduced though

Sent from my SM-G892A using Tapatalk

[PCO6]

I was faced with this on my old XJ.  I'm not sure how you use your MJ or if it's a look that that you'd want but I found it MUCH easier to go the 2"x6" slider route.   I cut the original rockers out and found that a lot of the original sheet metal they were welded to needed repair/replacement too.  I decided to gut everything and it made the job pretty straight forward.   You could play a bit with 2"x5" or even 2"x4" tubing if you want to tuck the rockers in more to make them less noticeable.