jeep690 Posted September 11, 2017 Share Posted September 11, 2017 So I'm thinking of doing a Rusty's 6.5" long arm kit on my 89' but while inspecting the body side LCA mounts, I noticed they were different from an XJ's. They look like they have more support on the outboard sides. So, my question is, when it comes time to hack all that off, will everything still be structurally sound. There is quite a bit of material to remove is all. Also, if anybody has pictures they can share of their undersides I would appreciate it! Link to comment Share on other sites More sharing options...
WyoCherokee Posted September 11, 2017 Share Posted September 11, 2017 i need to do this on mine for the cav-fab 3 link. I'm just going to trim out the center section and fold them under. kind of like a burrito, and weld them closed to the unibody rail. Link to comment Share on other sites More sharing options...
jeep690 Posted September 11, 2017 Author Share Posted September 11, 2017 Ok that is a good visualization. Looks like all that metal needs to be removed. Especially since Rustys has that uniframe tie in bracket that runs about a 1' down the outboard side of the uniframe. Link to comment Share on other sites More sharing options...
mnkyboy Posted September 12, 2017 Share Posted September 12, 2017 Once you remove the extra brace from the MJ the mounts are the same as an XJ, you can take everything off just like you would on a XJ. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now