richasco Posted August 29, 2017 Share Posted August 29, 2017 Putting my project up for sale, and when I say project I mean it. This Comanche is about 80% complete. The cab corners/rockers/uniframe are solid and nearly rust free. The floor pans aren't too far gone yet. But the drivers side is starting to go along with transmission tunnel. I'm just can't put the time in to finish it before it is no longer a viable project. See my posts in the registry for a few more details. It started out as a 2wd 2.8. It now has a later 4.0l AW4 and NV231 in it. The wiring harness/dash/steering column are from a 1996 Cherokee. It has a tan dash/center console/door panels from a Cherokee. It has Comanche bucket seat brackets as well. I found a bed for it that could be saved with a bit of work. I was planning on cutting off the bedsides to make an offroad bed for it. It also comes with rollbar brackets but no rollbar. I'm sure there is more that I have forgotten so please ask or request pictures(I have pretty good pictures of just about everything but too much to upload here). Asking $1,400 obo. Link to comment Share on other sites More sharing options...
kryptronic Posted August 31, 2017 Share Posted August 31, 2017 I'm in York PA and would be interested in those rollbar brackets if you're willing to sell them separately. Thanks. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.