hick92 Posted September 2, 2011 Share Posted September 2, 2011 i know i read it here before but i can't seem to find it now but at what will make it turn on i think when the a/c is on but i don't remember Link to comment Share on other sites More sharing options...
Boots Posted September 2, 2011 Share Posted September 2, 2011 It should come on with the AC and when the engine reaches a certain temp. There should be a switch thing in the radiator. Link to comment Share on other sites More sharing options...
hick92 Posted September 2, 2011 Author Share Posted September 2, 2011 ok thanks can someone please tell me where exactly this switch is located Link to comment Share on other sites More sharing options...
JeffN Posted September 3, 2011 Share Posted September 3, 2011 mine was drivers side on the radiator, there is a fan relay that will go bad also, it is on the drivers side fenderwell Link to comment Share on other sites More sharing options...
89er Posted September 3, 2011 Share Posted September 3, 2011 Is the fan running when the ac is on? See my aug 24th post and the info I got. I am still not sure that the aux fan is working off the switch as my truck never gets to the 230 mark, but replacing the ac relay on pass side fixed the running hot problem for me and fixed the ac. The relays in the system are all the same and about 10 bucks at auto parts store. I bought one and started at the radiator and exchanged it out till I found the bad one, so unless you have more than one bad relay you can run a test on system with just one. I found a wiring diagram in the dyi section under aux fan does not turn on. Good luck Ron Link to comment Share on other sites More sharing options...
ParadiseMJ Posted September 3, 2011 Share Posted September 3, 2011 mine was drivers side on the radiator, there is a fan relay that will go bad also, it is on the drivers side fenderwell This is the aux. fan temp switch on a RENIX radiator Some HO radiators come with the bung under a plastic plug, most don't. If it has a neck for the cap, it likely doesn't have the switch. The temp. SWITCH runs thru the ECU and then the fan relay (on the DS fenderwell like JeffN said), the temp SENDER in the block for the gauge/light, the Coolant Temp SENSOR in the block under the manifold to ECU for fuel/air mix. Link to comment Share on other sites More sharing options...
mvusse Posted September 3, 2011 Share Posted September 3, 2011 On HO engines there's a temp sensor on the thermostat hosing that runs through the ECU. Also some Renix 4.0s didn't have an auxiliary fan as my 87 doesn't even have the plug for one, or the relay for that matter. Link to comment Share on other sites More sharing options...
ParadiseMJ Posted September 4, 2011 Share Posted September 4, 2011 My 88 did not have a fan, but it does have A/C and the relay as well as the plug and wiring. It was easy to wire it to a switch. I converted the cooling system to a post 91 set-up, open, with a HO raidator. There was no bung for the RENIX switch. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now