shelbyluvv Posted January 3, 2010 Posted January 3, 2010 I need the stock rear shaft out of a, swb,_4.0,___aw4,___np231,___d35= 42.35" or swb,_4.0,___ax15-ba10/5,__np231,___d44= 42.25" U-joints can be bad. I will rebuild it. I will need it shipped to GA (30102). Thanks in advance, Bo.
johnnyc Posted January 3, 2010 Posted January 3, 2010 Bo...I should have my old driveshaft out in the side yard. It is from a SWB...4.0...AW4...231...Dana 44. I'll check the measurement in the morning.
shelbyluvv Posted January 4, 2010 Author Posted January 4, 2010 I am soooo going to kiss you on the mouff when I get back home! (even if you don't still have the driveline) See ya soon buddy!
johnnyc Posted January 4, 2010 Posted January 4, 2010 Well Bo, I just measured the shaft and from u-joint to u-joint, it's 41-3/16". Sounds like it's about an inch too short. You can have it if you want it. But only if there's no kissing involved. ;)
shelbyluvv Posted January 4, 2010 Author Posted January 4, 2010 Johnny, It should work. My truck now is a SWB, 4.0, AW4, 242, and D44. I can't see why it would not work for me. Get me the total shipped to 30102 and I will send you the cash for it.
Recommended Posts