Jerry Posted May 22, 2009 Share Posted May 22, 2009 Hi guys, I had a quick search but didn't find any posts relating to this issue so hoping someone can help point me in the right direction :D All of a sudden my fuel gauge has decided it won't read any more than quarter tank?! Is this a common problem? It has always worked fine until now when after I had parked on a steep side camber it suddenly went from full tank to quarter and stayed there. It had a moment a few days back when it started to work again for a couple of minutes but then it went back to quarter tank. It does seem to move as the fuel level goes down but not much. Are there any usual suspects? I was thinking maybe a bad connector somewhere but I'm not sure where to look. I gave what I'm guessing is the sender unit (on the tank RH side) sharp tap hoping if something was stuck it'd free up but it didn't make any difference. Any ideas? Thanks hugely :cheers: :bowdown: Link to comment Share on other sites More sharing options...
CWLONGSHOT Posted May 23, 2009 Share Posted May 23, 2009 I would check the plug, wires going to and from then negative grounds... Other than that, the float could have sprung a leak, a wire broke inside or the float arm has been damaged. Have you had fuel stolen recently? CW Link to comment Share on other sites More sharing options...
Jerry Posted May 23, 2009 Author Share Posted May 23, 2009 OK, I'll see if I can get the connector block on the tank off to see if that's corroded. No fuel stolen. I'm guessing there's a bad connector somwhere because the gauge did start to work properly for a short time. Thanks for the info :cheers: Link to comment Share on other sites More sharing options...
tj21 Posted July 26, 2010 Share Posted July 26, 2010 Hi guys, I had a quick search but didn't find any posts relating to this issue so hoping someone can help point me in the right direction :D All of a sudden my fuel gauge has decided it won't read any more than quarter tank?! Is this a common problem? It has always worked fine until now when after I had parked on a steep side camber it suddenly went from full tank to quarter and stayed there. It had a moment a few days back when it started to work again for a couple of minutes but then it went back to quarter tank. It does seem to move as the fuel level goes down but not much. Are there any usual suspects? I was thinking maybe a bad connector somewhere but I'm not sure where to look. I gave what I'm guessing is the sender unit (on the tank RH side) sharp tap hoping if something was stuck it'd free up but it didn't make any difference. Any ideas? Thanks hugely :cheers: :bowdown: I have the same problem, did you find a solution? My gauge never goes above 1/4 tank, but it works fine below that. Link to comment Share on other sites More sharing options...
ComancheKrazy Posted July 26, 2010 Share Posted July 26, 2010 I had a problem like this a year or so ago with my jeep. I filled it up and it only read half a tank. Did that for a couple of weeks then fixed itself. I don't know...the arm might have gotten stuck or something. I'm lucky though. Hope you figure it out. Link to comment Share on other sites More sharing options...
one_bad_MJ Posted July 27, 2010 Share Posted July 27, 2010 my fuel light will turn on at 1/4 tank then it drops more then it will be serious and be low fuel whats up with that Link to comment Share on other sites More sharing options...
tj21 Posted June 26, 2011 Share Posted June 26, 2011 Hi guys, I had a quick search but didn't find any posts relating to this issue so hoping someone can help point me in the right direction :D All of a sudden my fuel gauge has decided it won't read any more than quarter tank?! Is this a common problem? It has always worked fine until now when after I had parked on a steep side camber it suddenly went from full tank to quarter and stayed there. It had a moment a few days back when it started to work again for a couple of minutes but then it went back to quarter tank. It does seem to move as the fuel level goes down but not much. Are there any usual suspects? I was thinking maybe a bad connector somewhere but I'm not sure where to look. I gave what I'm guessing is the sender unit (on the tank RH side) sharp tap hoping if something was stuck it'd free up but it didn't make any difference. Any ideas? Thanks hugely :cheers: :bowdown: I have the same problem, did you find a solution? My gauge never goes above 1/4 tank, but it works fine below that. Answering my year old question, in case someone else has this problem. My cluster was bad, and after doing a cluster swap, the fuel gauge worked properly. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now