frankMart Posted November 22, 2012 Share Posted November 22, 2012 Hi everyone! Replaced the clutch a week ago: slave cylinder, presure plate, disc, and had the flywheel surface machined. Has a very firm pedal and everything works fine, but today I noticed a strange "Ticking" noise coming from below the engine. It stops when I depress the clutch pedal just a little. Someone experimented this problem? Could it cause any damage? (Sorry for my english, i'm working on it :thumbsup:) Link to comment Share on other sites More sharing options...
tommy90 Posted November 24, 2012 Share Posted November 24, 2012 If it is an internal throwout bearing check the holes where the bleeder is sticking out of to see if the rubber grommets in the Hole for the bleeders to stick out of is gone.if not line with hit the case being there's no rubber grommet there.happened on my 2.5 4 speed after I did the clutch,did the same thing.just give it a look its probably what it is.good luck. P.s my clutches throwout bearing went 4 month later after letting it tick.guessing my line from the throwout bearing got a hole from rubbing Link to comment Share on other sites More sharing options...
tommy90 Posted November 29, 2012 Share Posted November 29, 2012 Any luck? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now