receiver hitch at the pull & pay

[airspeed]

Found a nice receiver hitch at the pull & pay but don’t know how to get it off. I put a wrench on the bolts and they just spin the nuts inside the box frame member. There is no access to the back side to hold the nuts? Not sure how to cut the bolt heads, any ideas… I can't afford to buy any new battery powered tools.

[MJCARENA]

open end wrench thru the end of the frame rail. If your wrench is not long enough just tape an extension to it.

[airspeed]

That my friend is a good call. :bowdown: I would not have seen that opportunity with the rear bumper in place. :doh: I have a set of deep offset wrenches that will do the trick.