coon.hunter_21 Posted February 17, 2011 Share Posted February 17, 2011 next weekend is my set date to pull up the carpet.i have thout about the ben liner stuff to put over it.I'm tearin out all the carpet and rubber.so it will be bare metal. what is your guys expiriances and any tips on this project? Link to comment Share on other sites More sharing options...
05mxdiesel Posted February 17, 2011 Share Posted February 17, 2011 I just did this last week. If you have a angle grinder with a wire wheel, use that and for the areas you can't get to with the grinder use a drill and a small wire wheel. I put 1 coat of por 15 down and then two coats of undercoating. I only had a couple of small pin holes which I just tacked them shut with my welder. Also I wire wheeled the bottom of the floorpans and put the por 15 on the areas there was surface rust and then put about 3 heavy coats of undercoating. Pull up the firewall padding and paint under there as well. Link to comment Share on other sites More sharing options...
coon.hunter_21 Posted February 18, 2011 Author Share Posted February 18, 2011 whats por 15? and i plan on fixin the rusty spots. is the any alternitive to firewall paddin? and where do you get that stuff at? Link to comment Share on other sites More sharing options...
mvusse Posted February 18, 2011 Share Posted February 18, 2011 http://www.por15.com/ Link to comment Share on other sites More sharing options...
coon.hunter_21 Posted February 18, 2011 Author Share Posted February 18, 2011 sweet stuff.do u put that on and then the underbody coating? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now