Jeepyjeepy

The nuts that hold the crossmember on on the bottom of the fram rail are m10x1.5

Nah I'm in ks :(

Hey guys. I have a 88 mj 2wheel drive 4.0. The block and flywheel are out of a 94 though so i don't know if i need a pre ho (for renix speedo/wiring) or ho if they can be hooked to my stock components. Need it complete with mount slave etc preferably. My ba10 is trying to crap out. I also at least need the slip yoke protion of the driveshaft. I have a longbed. I'm located in ks 67211 for shipping quotes

I found a place in town that sells them and am gonna head there tomorrow, but when i told him a couple of the caps went in pretty dang easy he told me to bring the shaft too so he can have a looksee (they service and build driveshafts too). I figure why not since its a 'two' piece. And i'm still getting vibes. Thanks for all the help!!

So is spicer low end ir high end? I don't like to skimp.

Hi guys. I recently bought an 88 4.0 ba10 long bed mj. It had drivetrain vibes from 35 on up. Front u joint was bad. Autozone can't even get em but oriellys had em. So upon install i found that they don't fit quite perfect. Especially when i put the driveshaft back in. The two tabs on the rear pinion that hold the caps I'm center arent even touching the caps..... so i need to know the best place for quality joints. :help: