1988manche

Thanks ya i might just end up doing that, also does anyone know any drive shaft that is 42 inches long? I measured mine and it seems the cherokees is nowhere near what i need. So far i have only found tom woods custom ones

So you think if i just buy a new front section of it then i should be good? Something like this

I have a 97 swapped comanche and i am trying to hook the exhaust up but it seems anyway i connect it to the header it will be pointing the wrong way, is the exhaust compatible or do i need the exhaust from the cherokee?

Guess it wouldn't hurt to try ha

So this would get plugged in place of one of the bulbs?

This is what i was trying to ask ha, i wasn't sure if they were the same plugs or not

I have the entire interior swapped over from a 97 plus the engine and trans, i was wondering what work would be done to keep the front end, fenders and front clip from the comanche. I would think the front headlight harness from the comanche does not plug up with the rest of the cherokee wiring

So if you use the older fenders you won't have this problem right? Also then the 97+washer bottle won't fit behind the fender from what i have been reading

Yes xj swap, so what would you have to do to keep the front end original?

Just wondering if anyone has done the 97+ swap but left the front end alone. I would assume you would need to relocate the washer bottle and rewire the lights but other than that is there anything else in the way?

Newly rebuilt engine never had it running and when i go to crank it, it makes this puffing noise. Could this be my timing off? 20190528_140201_1.mp4

Stumped the forum on this one i guess ha

I have not had it running. But those years its directly on the pump, so I'm assuming the dakota pump has one on it too, is there anyway to test just the regulator?

So i have the 97+ swap with the dakota fuel tank and pump, i go to start it and i can hear the pump kick on but it just keeps cranking. I hooked up a fuel pressure tester and it only goes up to 20 while cranking. Is my fuel pump bad? It has a brand new fuel line 20181216_103154.mp4

Quick update, found the ground and grounded it. I can hear the fuel pump turn on and i primed it a few times tried to crank and it still won't start, tried disconnecting the fuel line at the fuel rail and nothing came out but if i disconnect it at the pump i get some gas coming out, could it be a clogged line?