dakal Posted December 2, 2011 Share Posted December 2, 2011 a new thread from(school me on renix engine). thanks to cruiser54 for the info. i decided to clean this connector because i have a long standing miss. here is a couple of pics with it cleaned. that tar stuff was very time consuming to get off. it was as hard as asphalt. repeated washings and 6 scrapings later, the pics show the result. so i drowned it in dielectric grease and put it back together. i will post later any results. cruiser's info about the factories grounding problems is good enough for me to do it. i had already done the engine ground with a completely new grounding system, so ok there. dave Link to comment Share on other sites More sharing options...
cruiser54 Posted December 3, 2011 Share Posted December 3, 2011 I stole one of your photos!!! Thanks in advance. Link to comment Share on other sites More sharing options...
dakal Posted December 3, 2011 Author Share Posted December 3, 2011 haha Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now