Search the Community
Showing results for tags 'converter'.
Found 2 results
-
I don't know if this goes in Tech, or Pub, so relocate if necessary and apologies. My gallon just of RustX froze. Or rather, my neighbor gave me a free gallon of it and he had let if freeze. Anyone with chemical experience: can I put it in a blender and make it good again? (there was an inch of gooey, grainy stuff in the bottom of the jug. Not easy to break up. But I figure a blender could smooth it all out again. What I don't know, is did freezing completely ruin the ingredients, or just solidify them a bit? My MJ is terribly rust covered.
-
I need help please someone. i made a rookie mistake because well....I'm a rookie. so i have an 88 comanche that is going to hopefully have a 6 cyl 4.0 and auto trans that I'm removing from a 91 cherokee donor. from what i can tell should be a direct bolt up. my issue is i pulled motor and trans and un bolted trans from engine. i unbolted the torque converter first however I'm a dumbass and didnt mark the torque converter to the flex plate now i don't know the way i should re-bolt it up for it to work right with the crank positioning sensor i believe. sorry for the inconvenience and thank you for replies. ~Oly~
