Jump to content

Search the Community

Showing results for tags 'axle shafts'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Comanche Club Forums
    • Comanche of the Month (MJOTM)
    • The Pub
    • MJ Tech: Modification and Repairs
    • Cruiser54's Renix MJ and XJ tips
    • MJ Hardcore Tech: Epic Journeys to Greatness
    • the Street Comanches
    • MJ Tech: DIY Projects and Write-Ups
    • Member Projects: Your Comanches
    • Member Projects: Other Cool Stuff
    • Comanche Registry
    • Adventure Planning / Regional Groups
    • Classifieds
    • Forum Issues, Ideas, Testing

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 2 results

  1. Hello all, I'm running into more problems than I think is normal on my front diff. (Decided to put a locker in and install a one piece axle on the passenger side). First, when pulling out the original 2 piece axle, it was extremely hard to remove. In fact, we had to weld the two axle pieces together in order to remove it. Seal location was moved from the CAD to the center diff housing, and we thought that the worst was over, but the hole on the passenger side is microscopically too big for the seal that commonly works there when doing this conversion. In the end we ended up using JB weld to keep the seal in. (Using regular sealant the seal would pop out, we could never get a pressure fit, and the seal needed to be so minimally larger that they didn't make one in that size. Today I put the carrier back in (locker installed) and I can't get the passenger side axle shaft in. I know sometimes it can be a pain, but remember my problems taking it out. Is there something off about my differential that I don't know about? Were some made with different bores near the carrier since they had the CAD system?! Need some help getting this one figured out. Seems like this diff just has a few odd things about it that we can't get figured out. What would cause the carrier to not line up correctly with the axle shaft?? Carrier is fully installed and torqued to spec. Thanks all
  2. I am looking for a good set of Dana 44 axle shafts and Drum Backing Plates. Purchased a used 1987 XJ Dana 44 axle and it has a bent shaft, go figure... Thanks
×
×
  • Create New...