Search the Community

1986 Jeep Comanche "Graham Cracker" 4.0 High Output I6 / AX15 transmission / NP231 t-case / Front Axle is a Dana 30, Rear Axle is a Dana 35 Build date: 3/19/86 Current Location: Chandler, Arizona Status: Daily Driver and weekend rig Notes: This is my second Jeep Comanche. I foolishly traded my old one for a Honda Accord in an attempt to get better gas mileage and have regretted my decision ever since. Which brings us to today. Body and Chassis are the 86 Comanche MJ, literally everything else is out of a 1996 Cherokee XJ. Over 10k in this truck and it runs strong. 4.5 inch lift (not spring over axle) sitting on 31's. Long bed with a JCR steel bumper and historic plates. Original 10 slot grill with an all black/tan interior, american racing wheels, and the underside is bedlined to prevent rust/debris damage. Hood has hood pins instead of a latch, and theres an electric fan installed. The paint job is Maaco but its the most expensive package so here's to hoping it will last more than 2 years. Current owner: Me myself and I

I have an '86 Comanche 2.5L with Throttle Body Injection and a AX4, 4-speed manual. The engine is not the original Comanche engine, but one from a YJ Wrangler from what I would assume is similar in year and function. Anyway, I was driving it the day before last to work and it was doing fine until it warmed up. All of a sudden, it just acted like it wasn't getting gas when I pressed the accelerator. It idled back down and was running rough, but as soon as I tried to give it gas, it would spit/sputter and bog down. It shut off on its own, so I gave it a few seconds and then I started it back up and the problem went away, for a little while anyway. I got about 2 miles further down the road and then the same thing. That time, I cut the engine off and restarted it about 10 seconds later. I made it all the way to work from then on without hesitation. On the way home from work, the same thing happened 3 more times. Anyone have any ideas on what this could be caused by? It has new spark plugs, a clean air filter, fuel injector cleaner and Iso-heet (water remover) in the gas. Edit... I took it for a test drive today with my dad to see what he thinks, and it did it about 4 times just going a couple miles down the street. We both feel as though it something fuel related or sensors starving it of gas. I have noticed a pattern, however. When it begins these spells of bogging down, I will turn of the engine and start it again while I'm coasting (did that all 4 times during today's drive). Once it's been restarted, it runs and drives perfectly fine for a little while until the issue arises again. It's the damndest thing because I don't have a clue how to begin sourcing the problem... I imagine just strictly looking at the fuel system, there are really only four main components: Fuel pump, fuel filter, pressure regulator and TB injector. The FP seems to prime fine and I can hear it running when idled and what not, though I haven't tested it for the 14-15 psi pressure that's needed. The fuel filter looks to have been recently replaced by the previous owner as it appears new from the outside. The TB injector seems to be spraying good and in a conical fashion. I haven't put a vacuum meter on the regulator, but that's next. Also, it's been suggested on CherokeeForum that it could be my TPS. I will be checking that with my digital multimeter. The O2 sensor appears to have been replaced by the PO. So, as far as sensors go, I don't know what else could alter the A/F ratio. I guess the most confusing part of it all is that when I cut it off and restart the engine, it runs fine for a little while. It's very random when the symptom occurs. Anyway, sorry for the long post, but I really need to figure it out soon because I'm about to stop driving my XJ to swap in a stroker. Any help or advice on this MJ issue would be greatly appreciated. Forgot to mention, the PO removed the cat and just ran a pipe to the muffler, so a clogged cat can't be an issue. Sorry if speaking of this is against forum rules, I am simply mentioning it to eliminate that as a potential issue...