Beorn of Ga

I have a 86 Comanche. I want to remove the bench seat to clean up the floor boards. Problem is a couple of the 13 mm nuts holding the seat to the floor boards are rusted to the point that a boxed end wrench slips. I tried vice grips, but no luck. it looks like the studs for holding the seat down are in the frame and not accessible. Any suggestions?

I have the traditional leaking clutch cylinder. Does it unbolt from the fire wall without me having to get to hardware inside of the cab ?

What a dummy I am! I didn't notice that the list below the Forums tab are categories. I just assumed they were post. Thanks.

I clicked on an existing post and asked the question as a comment to it. I replied to your comments. I'm asking how to initiate a new post, Or is what I did the way to go?

OK, I'm positive there is no green "button" to start new post above the green bar over the list of post on my version of the web page. I'm missing something, but I don't know what?

I can't find a way to start a new post on this site. Please help!