Aussiemj Posted October 30 Share Posted October 30 Hi guys I have to refit my headliner is there any instructions to be found Thanks Paul Link to comment Share on other sites More sharing options...
pizzaman09 Posted October 30 Share Posted October 30 It's fairly simple but one has to be careful of not bending it and kinking the backing. The easiest way is to remove the A pillar and B pillar trim as well as the trim above the doors. I did it with only loosening the A and B pillar trim but needed the assistance of a second person. There is a piece of Velcro near the center back of the headliner to help keep it in place there, the front is basic held in with the sun visors and sun visor clips. The other trim holds it in on the sides. Link to comment Share on other sites More sharing options...
JZLAJeep Posted October 30 Share Posted October 30 We've done several headliners with a can of headliner adhesive and a couple yards of fleece from the fabric store. We documented the Comanche headliner to some extent here: Link to comment Share on other sites More sharing options...
Aussiemj Posted October 30 Author Share Posted October 30 thank you i just have two metal clips not sure how they fit in Link to comment Share on other sites More sharing options...
M.T.Hands Posted October 31 Share Posted October 31 8 hours ago, JZLAJeep said: We've done several headliners with a can of headliner adhesive and a couple yards of fleece from the fabric store. We documented the Comanche headliner to some extent here: Thanks for posting the link to the other thread, I know this repair is in my future Link to comment Share on other sites More sharing options...
GonzoTheGreat Posted October 31 Share Posted October 31 If I recall, I had a metal clip on the driver side that supported the headliner, while the passenger side rested on the grab handle. There was also a piece of Velcro at the front center, and rear center on top. So it was fully supported before reinstalling the trim and visors. Link to comment Share on other sites More sharing options...
Aussiemj Posted October 31 Author Share Posted October 31 Thanks Link to comment Share on other sites More sharing options...
Htchevyii Posted November 2 Share Posted November 2 Mine have usually had the metal clip on both sides. You can see where it attaches. I think it's just there to hole the liner in position until the trim is installed. If you need to recover it, this might help. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now