Jump to content

Recommended Posts

after reassembling everything in Brianne's truck (88 4.0) the idle sounds rough and it stalls out if you rev too quickly, and if you do rev it up, it'll stall once it gets back down to idle.  but it will rev and sounds fine doing it.  Ive fiddled with things, checked my vacuum lines again, and swapped out the IAC with no changes.  the gas is a year old so I'm thinking of grabbing some octane boost and fresh gas tomorrow and see if anything happens.  :dunno:

Link to comment
Share on other sites

Poor response to throttle input is often a throttle position sensor issue. Its also a symptom of a weak fuel pump or other fuel delivery issues although usually closing the throttle will improve things in that case.

I also did once get a distributor put in one tooth out, which was close enough the engine would idle but wouldn’t always stay running and didn’t want to change rpm. But that’s an HO, not a Renix

 

I wouldn’t expect year-old gas to be bad enough to stall the engine but it is a lot hotter down your way and fresh gas can’t hurt anything.

Link to comment
Share on other sites

dumped in a booster and a couple gallons of fresh gas.  after a bit of the normal struggling (I'm assuming this was burning off the gas in the line), it no longer stalls out, but still lopes. I'll just start a new thread about the idle.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...