acfortier Posted February 23, 2023 Share Posted February 23, 2023 Looking for a PDC from the ‘91 era so I can wire in some new circuits to my MJ and make it as stock as possible. Thanks! Link to comment Share on other sites More sharing options...
schardein Posted February 24, 2023 Share Posted February 24, 2023 On 2/22/2023 at 8:38 PM, acfortier said: Looking for a PDC from the ‘91 era so I can wire in some new circuits to my MJ and make it as stock as possible. Thanks! Are you looking for one with the wires cut a few inches after they come out of the PDC? I could probably get one in a couple weeks from a local junkyard. Link to comment Share on other sites More sharing options...
acfortier Posted February 24, 2023 Author Share Posted February 24, 2023 3 minutes ago, schardein said: Are you looking for one with the wires cut a few inches after they come out of the PDC? I could probably get one in a couple weeks from a local junkyard. Yep, exactly--would be looking to de-pin some of the terminals w/ pigtails from the PDC so I can butt connect a new wire to it. Link to comment Share on other sites More sharing options...
schardein Posted February 24, 2023 Share Posted February 24, 2023 13 minutes ago, acfortier said: Yep, exactly--would be looking to de-pin some of the terminals w/ pigtails from the PDC so I can butt connect a new wire to it. That's what I did for my LS swap CJ. Used the PDC from a 91-95 XJ/YJ and completely rewired it. There is a 92 XJ at the local PnP. I will be going there in the next two weeks. If it's still there, they list "fuse box-bare" for $21.99. So that, plus shipping. Do you need the metal mounting bracket it clips into? Link to comment Share on other sites More sharing options...
acfortier Posted February 24, 2023 Author Share Posted February 24, 2023 Nice! I don't think I will need the bracket, but if it's there and doesn't cost extra, can't hurt to grab it? Thanks! Link to comment Share on other sites More sharing options...
boxyjeep Posted March 7, 2023 Share Posted March 7, 2023 I used a 97+ PDC and fully rewired my Renix to be super clean and minimalistic. If I could do it again, I would just get an aftermarket fuse/relay center like this one. As much as the factory look is nice, many parts of the plastic housing are brittle and might break if you try to pull any of the connectors out. It's also impossible to find new terminals. Link to comment Share on other sites More sharing options...
Recommended Posts