Jump to content

My New Floors


Recommended Posts

4 minutes ago, Jesse J said:

they look good! where did the crossmembers go?

I did alot of research online about keeping vs eliminating, and found they weren’t really needed. The driver side was completely gone, and the passenger side was too far pitted to salvage. I just cut where the studs were and welded those sections back in. 

Link to comment
Share on other sites

1 minute ago, PFCLeist said:

I did alot of research online about keeping vs eliminating, and found they weren’t really needed. The driver side was completely gone, and the passenger side was too far pitted to salvage. I just cut where the studs were and welded those sections back in. 

ok cool they look really good. was that rattle can bedliner?

Link to comment
Share on other sites

On 1/6/2021 at 12:06 PM, Jesse J said:

ok cool they look really good. was that rattle can bedliner?

The base was por 15, then a floor pan primer, and two coats of a spray on bedliner. for the underside by the exhaust I used a ceramic high temp coating. And thanks

Link to comment
Share on other sites

18 hours ago, ghetdjc320 said:

Your floor mats will fit better without the braces lol

Your right, haha. I think I’ll leave them bare, though. I put rubber drain plugs on each side I’ve been using alot, and until i find this leak, ill leave em out

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...