Jump to content

Manual Clutch/Brake pedal assembly


Recommended Posts

I have most of an AX-15 swap at my house ready to go in the truck (maybe over Christmas). If anyone has a pedal assembly for a manual trans I am on the lookout for one. 

 

Thanks, 

Torq

Link to post
Share on other sites

I do not have either, but you may want to specify whether or not you want a 97+ clutch/brake pedal assembly or a 87?-96 clutch pedal assembly because the firewalls on the  87-96 rigs are different from the 97+. If you are sticking with the Renix era front end, you will probably want a 87-96 assembly.

Link to post
Share on other sites

Definitely pre-97. But that is a good point. I don't believe there is a difference between 1987-1996 for the clutch pedal assembly but I may be wrong. I know I used a 1995 assembly on my old truck which was a 1989 but I don't recall if I had to make any modifications. 

 

 

Link to post
Share on other sites
9 minutes ago, Torq_Shep said:

Definitely pre-97. But that is a good point. I don't believe there is a difference between 1987-1996 for the clutch pedal assembly but I may be wrong. I know I used a 1995 assembly on my old truck which was a 1989 but I don't recall if I had to make any modifications. 

 

 

I'm no help here either. I would assume 84-86 would not work though because I know the firewalls were different on those rigs too.

Link to post
Share on other sites
10 hours ago, MiNi Beast said:

accidently you say. :bs:

Well it wasn't exactly planned. I wasn't looking for one per se... =P 

 

Couldn't pass up a running 1991 in better condition than mine. 

Link to post
Share on other sites
22 hours ago, Torq_Shep said:

Well it wasn't exactly planned. I wasn't looking for one per se... =P 

 

Couldn't pass up a running 1991 in better condition than mine. 

Welcome to the HO club :holdwrench:

Link to post
Share on other sites
×
×
  • Create New...