WolverineCub Posted July 5, 2017 Share Posted July 5, 2017 ??? I fixed the driver's side with overlapping good metal, body cement and rivets. Now I have a passenger floor pan that is flat. Do I cut out the ridge on the floor? Steve in Montreal Link to comment Share on other sites More sharing options...
cody4359 Posted July 5, 2017 Share Posted July 5, 2017 Depending on your rust issue, to do it to right you would drill the spot welds and remove the brace. I was able to salvage brace and put it back over the new pan. It's a complete pain in the asss Sent from my SM-G900V using Tapatalk Link to comment Share on other sites More sharing options...
Pete M Posted July 5, 2017 Share Posted July 5, 2017 most guys just remove the frame brace and discard it. Link to comment Share on other sites More sharing options...
WolverineCub Posted July 5, 2017 Author Share Posted July 5, 2017 Thanks Guys, You are da bomb. Going in for a paint job this Month. Steve From Montreal Link to comment Share on other sites More sharing options...
DesertRat1991 Posted July 5, 2017 Share Posted July 5, 2017 The link below was a pretty good write-up until about a week ago when Photobucket disabled 3rd party hosting. You can still see the pics you just have to open each in a new tab: http://www.jeepforum.com/forum/f11/how-i-just-put-new-floorpans-patched-holes-xj-lots-pics-372669/ Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now