Kalal92 Posted January 9, 2017 Share Posted January 9, 2017 Turns on with even with cold start. Happened after Replacing blower motor. Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
schardein Posted January 10, 2017 Share Posted January 10, 2017 I'm not a Renix expert, but I think my knowledge still applies. The switch is located at the back driver side of the cylinder head. Grounding the wire going to the switch makes the light come on. Your problem seems to indicate the wire is somehow being grounded. Did the wire somehow get pinched during the blower fan swap? Also a quick check to see if the switch just happened to go bad, do a continuity check-- remove the wire lead and check for continuity between the post of the switch and a known ground. If you have continuity, the switch is "on" all the time and needs replaced. Link to comment Share on other sites More sharing options...
Kalal92 Posted January 10, 2017 Author Share Posted January 10, 2017 I'll check that out Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
Dzimm Posted January 10, 2017 Share Posted January 10, 2017 If that doesn't work, try disconnecting your gauge cluster and reinstalling. I've had problems with my gauge clusters in the past and most of the time it was just a bad connection at the cluster. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now