crs88 Posted April 23, 2016 Share Posted April 23, 2016 I had a ton of slop in the shifter and when I pulled it to take a look, there is no bushing at the end of the shifter where it enters the transmission. It is flat at the end and goes into a notch, but I would think that a bushing would have been in place to avoid that slop and metal on metal contact. Yes? Anyone have any insight or the same issue at some point? Link to comment Share on other sites More sharing options...
crs88 Posted April 29, 2016 Author Share Posted April 29, 2016 Anyone have a pulled BA trans that they could take a look at for me? I'm having trouble lining up the gears when I'm shifting, but I don't think that it's the trans going bad. Link to comment Share on other sites More sharing options...
87MJTIM Posted April 30, 2016 Share Posted April 30, 2016 Here are pictures of my BA shifter: Hope these help. Link to comment Share on other sites More sharing options...
crs88 Posted April 30, 2016 Author Share Posted April 30, 2016 Yep. No bushing on yours either. Tells me it was this way from the factory. Thanks, man. Tell me...when you pulled that shifter it was in neutral, right? Was the slot perfectly centered in the top of the transmission? Mine is kind of off-center to the left. Link to comment Share on other sites More sharing options...
87MJTIM Posted May 1, 2016 Share Posted May 1, 2016 Honestly, I didn't pay that much attention. I reinstalled the shifter, ran it through the gears and put it back in the shed. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now