Jump to content
HOrnbrod

Adjustable MJ Load Sensing Valve

Recommended Posts

Bumping to say THANKS!  Found everything I needed to make an extended rod from Zoro.com for $22 shipped.  You can do it for less if you can find a smaller pack of hex nuts.  It worked out great.

 

1/4"-28 X 1' PLAIN 316 STAINLESS STEEL THREADED ROD:

https://www.zoro.com/value-brand-threaded-rod-316-ss-14-28x1-ft-s601402801pldar/i/G3609837/

 

FEMALE STUD ROD END, RH, 1/4-28:

https://www.zoro.com/qa1-female-stud-rod-end-rh-14-28-cfr4s/i/G5090626/

 

1/4"-28 PLAIN FINISH 18-8 STAINLESS STEEL HEX NUTS, 50 PK:

https://www.zoro.com/value-brand-hex-nut-14-28-gr-18-8-ss-plain-pk50-u511600250002/i/G5337805/

 

LmalCK9.jpg

 

YwmfTD4.jpg

Share this post


Link to post
Share on other sites

On my MJ, The lsv lever itself was mounted in the opposite direction or at the 8 o' clock setting looking from behind. I relocated the arm back to the 3 o'clock position as pictured above. There was no resistance felt and the lines are empty of fluid. When I refill the lines, will the LSV work as it should or do I have to perform an adjustment on it?. The PO must have had it apart at one point and didn't realize what it does or the valve itself works both ways?? I hope this makes sense?

Share this post


Link to post
Share on other sites
On 2/11/2020 at 7:40 AM, DC3 said:

On my MJ, The lsv lever itself was mounted in the opposite direction or at the 8 o' clock setting looking from behind. I relocated the arm back to the 3 o'clock position as pictured above. There was no resistance felt and the lines are empty of fluid. When I refill the lines, will the LSV work as it should or do I have to perform an adjustment on it?. The PO must have had it apart at one point and didn't realize what it does or the valve itself works both ways?? I hope this makes sense?

 

did you bleed the lines with the special factory MJ procedure?

Share this post


Link to post
Share on other sites

Not yet ,, Just replacing all lines from the distribution back...Hopefully by the weekend...Where can I find the procedure?

 

 

Share this post


Link to post
Share on other sites

should be somewhere in the link in my sig. 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...